CRU TeraCard E34-2S - Manual (Page 2)

User Manual for Express 34 Card A9-034-0001 REV 1.0
2.1. Windows 2000/XP or Windows Server 2003 Fresh Installation
Follow the instructions in this section if you are performing a new installation of Windows 2000/XP
or Windows Server 2003, and you wish to boot from a device attached to the SiI3132 SATALink
controller.
NOTE: If installing Windows 2000, you must first edit the txtsetup.oem file on the driver
installation disk and delete the line from the [Config.Si3132] section that reads:
value = Parameters\PnpInterface, "5", REG_DWORD, 1
1. Power off the system. Insert the SiI3132 SATALink controller into an available PCI slot.
Connect serial ATA cable(s) between the SiI3132 controller and the serial ATA device(s). Power
up the system.
2. Put your Windows 2000/XP or Windows Server 2003 CD into the CD/DVD-ROM drive, or on
Windows 2000, place boot diskette #1 in the floppy drive if your system cannot boot from the CD.
3. Press F6 for third party SCSI or driver installation at the beginning of text mode installation.
Press 's' when setup asks if you want to specify an additional device, and insert the diskette
labeled 'Silicon Image SiI3132 SATALink Driver Installation Disk'. Press 'Enter'. From the menu
presented next, press 'Enter' to select the 3132 controller.
4. Press 'Enter' again when prompted to continue on with text mode setup.
5. Follow the setup instructions to select your choice for partition and file system.
6. After setup examines your disks, it will copy files from the CD to the hard drive selected above
and restart the system. After restart the setup process will resume to finish the installation.
7. Once the operating system installation has completed you can follow the instructions in
Verifying controller installation to verify that the controller was installed correctly.
2.2. Adding the SiI3132 controller to an existing Windows 2000/XP or Windows Server 2003
installation
Follow the instructions in this section to install the Silicon Image SiI3132 SATALink controller into
a system already running Windows 2000/XP or Windows Server 2003.
1. Power off the system. Insert the SiI3132 SATALink controller into an available PCI slot.
Connect serial ATA cable(s) between the SiI3132 controller and the serial ATA device(s). Power
up the system.
2. During OS boot up, Windows will display the 'Found New Hardware Wizard'. Click 'Next'.
3. Select 'Search for a suitable driver for my device (Recommended)' and Click 'Next'.
4. Under 'Optional search locations' insure that 'Floppy disk drives' is checked.
5. Insert the diskette labeled 'Silicon Image SiI3132 SATALink Driver Installation Disk' into A:
and click 'Next'.
6. When the wizard indicates that it found a driver for the device click 'Next'.
7. If the 'Digital Signature Not Found' dialog appears, click 'Yes' to continue installing the driver.