Holland Electronics ST-5128S - Manual (Page 11)

10
2. Frequency Selection – The carrier frequency is displayed at the top of
the LCD screen. A specific center frequency can be selected using
either of these two methods:
a) Using the numeric keypad type in the frequency to
be measured in units of MHz. Then press the
MHz button to enter this number into the meter.
b) Press the MHz button. Then use the 
buttons
to change the carrier frequency in steps of 10 kHz.
When the meter is set to a frequency that is a carrier of an active stored channel,
then the channel number will also appear at the top of the LCD screen. If the
frequency corresponds to the video carrier, then the meter will display “CHV”
next to the channel number. If the frequency corresponds to the audio carrier,
then the meter will display “CHA” next to the channel number.
When the meter is set to a frequency that is not a carrier of a stored channel, the
meter will display “:???”
After the specific channel or carrier frequency is selected, the meter will measure
and provide the carrier power reading. The numerical result will appear in the
middle of the LCD screen. See figure 3.
SINGLE CHANNEL MEASUREMENT SUB-MENU
Pressing the F4 (NEX) soft key while in the Single Channel Measurement Mode
Main Menu Screen will step to the Sub-Menu (figure 4). The soft key functions
are as follows:
F1 – ALL – Changes the meter function to All-Band Frequency Scanning
Spectrum Analyzer Mode.
F2 – AC - Changes the meter function to AC Voltage Measurement Mode.
F3 – C/N - Changes the meter function measure Carrier / Noise Differential
F4 – ESC- Exits back to the Single Channel Measurement mode Main Menu.
CHV 12 216.25
MHz
7.4
dBmV
ALL AC C/N ESC
F1 F2 F3 F4
Frequency
measurement unit
Battery status
Current
channel
Fig.4 Single Channel Measurement Mode Sub-Menu