Junger Audio b45 - Digital Audio Delay - Manual (Page 13)

3. INSTALLATION
INSTALLATION
3.1
UNPACK THE UNIT
3.2
POWER SUPPLY
3
The digital audio delay b45 was carefully packed in the factory
and the packaging was designed to protect the equipment from
rough handling. Please examine carefully the packaging and its
contents for any signs of physical damage, which may have
occured in transit.
The digital audio delay b45 is a device under the safety category
Schutzklasse 1 in keeping with the VDE 0804 standards and
may only used with power supply installations built according to
regulations.
Check the voltage details printed at the rear panel are the same
as your local mains electricity supply.
The digital audio delay b45 is equipped with standard connectors
(see also chapter 3).
Before connecting the digital audio delay b45 switch the power
off at all connected units.
The digital audio delay b45 is made as standard 19“ unit (EIA
format). It occupies 1 RU (44 mm height) space in a rack.
Please allow at least addititonal 3“ depth for the connectors on
the rear panel.
When installing the unit in a 19“ rack the rear side of the unit
needs some support, especially for mounting in flight cases.
The digital audio delay b45 should not be installed near units
which produce strong magnetic fields or extreme heat. Do not
install the filter processor directly above or below power
amplifiers.
If, during operation, the sound is interrupted or displays no longer
illuminate, or if abnormal odor or smoke is detected immediately
disconnect the power cord plug and contact your dealer or
Jünger Audio.
3.3
CONNECTIONS
3.4
RACK MOUNTING
3.5
OPERATION
SAFETY
Operation manual b45 chapter 3 -installation- page 3-1