Junger Audio b45 - Digital Audio Delay - Manual (Page 23)

4. LOCATION OF PARTS AND CONTROLS
dsp
processing
AES
out
SDI
out
SDI
in
B4x
Split Mode
AES
in
External device
AES
in
AES
out
The selection of split mode (SDI DIRECT) is made by setting
jumper J1 on main board of the unit.
The 4-channel processors of b40 series fitted with SDI-interface
are compatibel with the standard SMPTE 272M-AB. They
support 48 kHz synchronous audio sampling with 20 bit word
length.
4.6
CONFIGURATION
OF SDI INTERFACE
The standard allows up to four groups each of four mono audio channels.
(Usually used by most of D-VTR's and other equipment is Group 1 with 48
kHz synchronous sampling.)
Group selection and other settings are to configure with
switches on the SDI board as described following:
Settings on SDI interface board:
SDI-
Interface
RX-GR0
RX-GR1
SWAP0
SWAP1
EXCHNG
R
E
C
E
IV
E
R
T
R
A
N
S
M
IT
T
E
R
TX-GR0
TX-GR1
CASCADE
PACK
TEST
Operation manual b45, chapter 4 -location of parts and controls- page 4-5