Lcd control – NEXCOM NEX 609 User Manual
Page 59
Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved.
45
NEX 609 User Manual
Chapter 3: BIOS Setup
LCD Control
This section is used to configure the LCD functions.
Chipset
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Select the video device which will
be activated during POST. This
has no effect if external graphics
is present.
Secondary boot display
selection will appear based on
your selection.
VGA modes will be supported
only on primary display
LCD Control
Primary IGFX Boot Display
Secondary IGFX Boot Display
LVDS1 Panel Type
LVDS2 Panel Type
Active LFP
LVDS1 Panel Color Depth
LVDS1 Backlight
LVDS2 Backlight
[CRT]
[Disabled]
[800x600 LVDS]
[1280x1024 ]
[Int-LVDS]
[18 Bit]
[100%]
[100%]
LVDS1 Panel Type
Select the LCD panel used by the LVDS1 by selecting the appropriate
setup item.
LVDS2 Panel Type
Select the LCD panel used by the LVDS2 by selecting the appropriate
setup item.
Active LFP
Select the Active LFP configuration.
No LVDS
VBIOS does not enable LVDS.
Int-LVDS
VBIOS enables LVDS driver by Integrated encoder.
LVDS1 Panel Color Depth
Select the Panel Color Depth for LVDS1.
LVDS1 Backlight
Adjusts the brightness of LVDS1 backlight.
LVDS2 Backlight
Adjusts the brightness of LVDS2 backlight.
Primary IGFX Boot Display
Select the video device which will be activated during POST. Has no effect
if external graphics is present. Secondary boot display selection will appear
based on your selection. VGA modes will be supported only on primary
display.
Secondary IGFX Boot Display
Select the secondary display device.