Connecting to vtc series with the lvds cable – NEXCOM VMD 1000 User Manual
Page 22
Copyright © 2012 NEXCOM International Co., Ltd. All Rights Reserved.
Chapter 3: Hardware Installation
14
VMD Series User Manual
2. Connect and fasten the DB26 end of the LVDS cable onto the LVDS port
of the VTC series.
CAUTION
: Make sure the power is off for VTC series before connect-
ing VMD 1000/ 2000 with VTC series via the LVDS cable.
If connection between VMD 1000/2000 and VTC series is made while
VTC series is already powered on, VTC series will shut down
automatically.
NOTE:
LVDS cable is only for VMD 1000/2000.
1. Connect and fasten the DVI end of the LVDS cable onto the DVI port.
NOTE
: Use only NEXCOM’s proprietary LVDS cable for this DVI port.
Pin assignments of this DVI port differ from those of the standard DVI
interface.
Connecting to VTC series with the LVDS Cable