One Systems Pole Mount Mini - Manual (Page 3)

1. NOTE: It is best to preset the desired pan and tilt angles PRIOR to mounting
the Pole Mount Mini on a pole. (Step 2 below offers details).
Use ONLY the supplied nuts and bolts to mount the PT-10 to the Pole Mount
Mini back plate. DO NOT substitute any parts!
Mount the pole mount section (see figure 1 above) of the bracket to the pole at
the desired height on the pole. The bracket is mounted to the pole using BAND-
IT stainless steel bands. DO NOT SUSTITUTE bands of other material or other
widths! There are three locations on the pole bracket for bands.
IMPORTANT: ALL THREE BAND LOCATIONS MUST BE USED.
Figure 2 below illustrates the locations for the stainless steel band clamps.
IMPORTANT: It is REQUIRED that each of the three bands be double wrapped.
Double wrapping will insure a strong and secure mounting of the bracket to the
pole. The stainless steel banding materials should be as follows:
BAND-IT # C206R9 stainless steel bands
BAND-IT # C25699 buckles
BAND-IT # C00169 tensioning tool
The stainless steel band is Type 201SS 0.030 inches (0.762mm) thick and 0.750
inches (19mm) wide.
WARNING: Do NOT substitute banding materials or banding dimensions.