Paxton Superchargers Universal Big Block Mopar 440 Carbureted System - Manual (Page 11)

3
P/N: 4809662
©2009 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
02NOV10 v2.0
Section 2
PREPARATION/REMOVAL
2.1 PREPARATION/REMOVAL
A. Disconnect the negative lead of all batteries.
*** NOTE ***
Refer to Fig. 2.1-a for the following steps.
B. Loosen all nuts and bolts that are used to ten-
sion the alternator and power steering pump
V-belts.
C. Remove all of the belts from the accessories.
D. Remove the stock crank pulley.
E. Remove the alternator stay (adjustment bar) and
retain hardware to be reused in a later step.
*** NOTE ***
If you have not changed spark plugs in the last 15,000
miles, do so prior to the installation of this kit.
Fig. 2.1-a
FACTORY
ALTERNATOR
BRACKET
FACTORY
CRANK PULLEY
ALTERNATOR
STAY
F. Remove any remaining hardware securing
the alternator to the cylinder head. The alter-
nator will be relocated in a lower position.
*** NOTE ***
If you are installing a universal supercharger kit,
some of the following instructions may not apply or
may require custom fabrication.
*** NOTE ***
The current setup of this kit requires the use of the
following components:
- Electric radiator cooling fan(s).
- Stock crank & accessory pulleys
- Electric fuel pump with boost referenced regulator
- Appropriate carburetor