Paxton Superchargers Universal Big Block Mopar 440 Carbureted System - Manual (Page 17)

9
P/N: 4809662
©2009 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
02NOV10 v2.0
Section 5
MOUNTING BRACKET/SUPERCHARGER
INSTALLATION
5.1 MOUNTING BRACKET INSTALLATION
A. Clean the front of the passenger’s side cylin-
der head so that the mounting spacers will sit
flat when installed.
B. Clean the front of the water pump bosses so
the supercharger bracket will mount flat
against the mounting surfaces.
*** NOTE ***
Refer to Fig. 5.1-b for assistance in the next few
steps. DO NOT tighten hardware until all fasteners
and spacers are installed.
C. Locate the mounting bracket assembly
D. Locate the three 3/8-16 x 6.5” bolts, 3/8 AN
washers, cylinder head mounting block,
1.691” spacer, and main supercharger mount-
ing bracket (See Fig. 5.1-a.)
E. Install two of the 6.5” bolts and washers
through the main bracket and then through
the cylinder head mounting block as shown
in Figs 5.1-b, 5.1-c. Make sure the side of
the mounting block with the center tapped
hole faces the rear side of the Main Bracket.
Fig. 5.1-a
Fig. 5.1-b
Fig. 5.1-c