TEKVOX TekManager and TekMonitor User Manual

TEKVOX Safety

Advertising
background image

TekMonitor Set Up Guide(V1.4)

For Non-Configured TekMonitors

August 5th, 2014


Overview: A TEKVOX TekPatrol

™-based system, including all TEKVOX Drop-Ins, requires

certain information to be programmed into the device prior to operational deployment. At a
minimum, this includes the following:

1. Campus name

2. Building name

3. Room number

4. Projector model number

5. Projector serial number

6. Tek 1201HD serial number

7. Tek 2 TekMonitor serial number (pre-programmed by TEKVOX).

The serial numbers are essential to TekPatrol’s asset management functions and cannot be
overlooked. TEKVOX offers free in-factory configuration for customer convenience if the above
information is provided with the product order (see TEKVOX Drop-In Worksheet.xls).

If you have received an unconfigured system, please follow the steps below to configure your
system(s). You will need:

1. TEKVOX TekManager software installed on a local Windows PC (contact

[email protected] if you do not have this software)

2. A CAT5e ethernet cable

3. A means to power the TekMonitor for configuration (see below)


Section 1: Establishing a Connection with the TekMonitor

1. Powering the TekMonitor: The TekMonitor can be powered through its 24V DC power

input or via a CAT5E ethernet cable with power (PoE or injected power). Please ensure

that the TekMonitor is powered.

2. Connecting to the TekMonitor: The TekMonitor is compatible with Ethernet and a

Cat5E wired connection between the Tek 2 and a router with DHCP must be

established. The TekMonitor will perform a DHCP request on power-up. (The order in
which it receives power doesn’t matter).

Advertising