TEKVOX TekManager and TekMonitor - Manual (Page 3)

information” block back in the “Locations” section by double clicking on one of the info
items on the Location Panel and pasting it in the resulting dialog.
3. Settings - Provides network settings, host settings, messages, and asset information.
Do not alter this section for the time being (v 1.2).
4. Devices - Provides drivers, inputs, and outputs : On the upper-left side just under the
graphic, you’ll see two sections for a “Tek 1” and “Tek 2”. The default setting should
already be set to “Tek 2”. If “Tek 1” is checked off instead, change it to “Tek 2”. Failure to
do this will result in not being able to apply a template to the Tek 2 in the “Finish”
section. To ensure that the projector will work, you have to make sure that you select the
correct drivers. To do this, click on “Driver 1” underneath the TekMonitor graphic. Make
sure that projector is selected on the top device type selection. The left side contains
manufacturer names such as Epson and Hitachi. Select the correct manufacturer on the
left, and then the model on the right*. If you have a Hitachi CP-X417 for example, you
will click on “Hitachi” on the left and “CP-X417” on the right.
5. Macros - Allows you to edit how a device functions (Not quite sure how to define it) :
The standard macros will be provided with the template. Do not alter this section for the
time being (v 1.4).
6. Events - Allows you to establish when a TekMonitor will run its macros. The standard
events will be provided with the template. Do not alter this section for the time being (v
1.4).
7. Schedules -
The control panel which lets you decide when to turn a TekMonitor’s
security or other control function on or off : The standard schedules will be provided with
the template. Do not alter this section for the time being (v 1.4).
8. Finish -
Select “Apply to Selected TekMonitor” from the top left of the Finish Pane. Click
the “Select” box and then select all TekMonitors that you wish to apply your information
to. This will also update the drivers and ROM. Total time should take around one minute
and 40 secon
ds. When you are done, click “save” at the bottom-right hand side.
9. You’re all done. Make sure you save the project before closing TekManager.