Set-up and welding, Connecting the welding leads – Tru-Weld TWE250 CD Welder User Manual
Page 12
12
CONNECTING THE WELDING LEADS
Connect the welding stud gun power cable into the (‐) terminal panel mount socket
(designated by the gun symbol) on the front of the welding unit.
***NOTE ‐ the cable end plug has a flat which aligns with a dot on the panel mount
socket. Secure the connector into the panel mount socket, and then turn it clockwise
until it locks into proper position. Failure to do so could result in damage to the con‐
nector.
Welding Gun Power Connector
Welding Gun Control Cable Connector
Connect the weld gun control cable into the center panel 2‐pin socket.
**NOTE ‐ the plug has a large pin and a small pin that match the socket on the unit.
This is to prevent incorrect connections. Push the plug firmly into the socket and
twist clockwise to secure the plug into the correct position.
SET-UP AND WELDING