Assembly instructions – United States Stove Company 2000 User Manual
Page 6
Advertising
6
Ussc
ASSEMBLY INSTRUCTIONS
Blower Assembly
THE BLOWER ASSEMBLY MUST BE DISCONNECTED FROM THE SOURCE OF ELECTRICAL SUPPLY BEFORE
ATTEMPTING THE INSTALLATION.
THE BLOWER ASSEMBLY IS INTENDED FOR USE ONLY WITH A STOVE THAT IS MARKED TO INDICATE SUCH USE.
DO NOT ROUTE THE SUPPLY CORD NEAR OR ACROSS HOT SURFACES!
Step 1.
Fix the assembly to the back of the stove with the four screws provided.
Pedestal Trim Assembly
Attach trim piece to the pedestal base at the location
shown using the screws provided.
Ash Pan Assembly
Remove ash pan from fi rebox. Under the fi rebox, there
are two brackets; Slide the ash pan into these brackets.
Advertising