WaveWare TMR1P - Manual (Page 17)

DAVISCOMMS (S) PTE LTD
6
. TMR EVALUATION KIT SET-UPS AND OPERATION
The Evaluation board is designed to facilitate the testing and evaluation of the TMR1P receiver
modules. It contains the following features:
• Built-in regulated DC power supply
• LED status indicators for the digital outputs
• Jumpers to select power source for the TMR1P
• Jumpers to select serial port operating mode (RS232 or TTL)
• Connection to programming cable
6.1 Evaluation Kit Hardware
Evaluation Board
Power Adapter, 12Vdc, 1 amp
Serial Cable; D-Sub 9 pins (male) to D-Sub 9 pins (female)
Programming Cable, DB25 female to RJ-45 (8 pins)
6.2 Evaluation Board Features.
- The Evaluation Board is designed to aid in programming, testing and to develop new
applications for the TMR1P Module.
- The 8 LEDs monitor signals sent to the digital outputs, D0 to D7.
- An LED turns on when the output bit is set to Logic High.
- An LED will turn off when the output bit is set to Logic Low or to High Impedance.
See Section 1.3, Output Control Codes, for information on how to send messages to the TMR1P
to control the digital output bits.
The Frequency and Capcodes can be programmed on the attached TMR1P module
through the Parallel Port on a PC. This will allow programming the TMR1P when it is
connected to the Evaluation Board.
17 500088R03
DAVISCOMMS (S) PTE LTD
Blk70 Ubi Crescent #01-07 Singapore 408570. Tel: (65) 65471127 Fax: (65) 65471129