WaveWare TMR1P - Manual (Page 3)

DAVISCOMMS (S) PTE LTD
1 TMR1P Product Features
1.1 Product Description
The TMR1P is able to receive alphanumeric messages and send via the RS232 serial output to
any industrial standard display device. The RS232 port speed of 1200/2400/4800/9600/19200
baud rate with even/odd/none parity option can be set through the TPS. TMR1P supports both
numeric and alphanumeric vector. However, there are some constraints in using numeric vector to
send the control codes for both control and display data, which will be specified in the relevant
sections.
1.2 Receiver Frequency
The TMR1P’s receive frequency is normally set during the production of the units in accordance
to customers’ specifications. The receive frequency can be changed by using the TMR
Programming Software (TPS) by programming the frequency synthesizer.
1.3 Multiple Addressing
The TMR1P can support up to 7 POCSAG capcode addresses.
1.4 LED Indication
The following table describes the different indications of the LED for different conditions:
S/No LED Indication Status Condition
01 Continuously on Reset is successful After Power on
02 Blinking every half a second EEPROM failure After Power on
03 Blinking every 2 seconds until
synchronization is restored Lost synchronization or Out
Of Range (OOR) Power on and in
Stand-by mode
04 Blinking every 0.3 second for
up to 3 seconds Receiving a new message Power on and in
Stand-by mode
1.5
Output Control Codes
The TMR1P is able to control different industrial applications such as motor, relay,
lighting and electronic-lock by sending the right control codes through its 8 output ports
(1/0/k/s/r).
When a port control code sent is “1”, the corresponding output port is set to high state or source
state.
3 500088R03
DAVISCOMMS (S) PTE LTD
Blk70 Ubi Crescent #01-07 Singapore 408570. Tel: (65) 65471127 Fax: (65) 65471129