Xtramus NuApps-SwitchPerform V1.8 - Manual (Page 14)

14
Please follow the steps down below to start NuApps-SwitchPerform and NuServer properly.
Starting NuServer
When starting NuApps-SwitchPerform, a “Connect
to NuServer” window will pop up and asked how
you are going to connect to NuServer.
• Local Host: Choose this option when you’re
running NuApps-SwitchPerform from
NuStreams-2000i IPC module or a PC that’s
connected to NuStreams-2000i/600i via an
RJ45 cable.
• Remote: Choose this option when you’re
running NuApps-SwitchPerform from other PC
located on the network. Choose the IP address
which is assigned to NuStreams-2000i/600i from
the scroll-down menu, or choose demo to enter
NuApps-SwitchPerform’s Demo Mode.
• Connect/Cancel: Click the Connect/Cancel
button to connect to NuStreams-2000i/600i or
cancel starting NuApps-SwitchPerform.
A “NuServer-NIC Information” window will pop
up. Please select the NIC (Network Interface Card)
which is connected to NuStreams -2000i/ 600i’s
from the Network Interface Information table,
and click OK. If you’re using NuStreams-2000i’s
IPC module, please choose “Realtek RTL8139
Family Fast Ethernet”.
NuServer will connect to the daughter boards, and
NuApps-SwitchPerform will start as well.
You now have access to NuApps-SwitchPerform’s
main display window.
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®