Status display / error codes – ZENNER multipulse User Manual
Page 9
Status display / Error codes
The symbols in the table below show the pulse counting module’s operational status. The status
messages only appear in the main display! The temporary display of the warning triangle can be caused
by special operating states and does not always mean that the device is malfunctioning. However,
should the symbol be displayed over a longer period of time you should contact the service company.
Error codes show faults detected by multipulse resp. multilog. If more than one error appears, the sum of
the error codes is displayed: Error 1100 = error 1000 and error 100.
Symbol Status
Event
Flow existent
-
Data transmission
-
Emergency operation
Exchange device
External power supply
-
Code Error
Event
100
Emergency operation
Exchange device
1000
Battery life time exceeded
Exchange device
> 8000
Internal hardware error
Exchange device
9