Adamson S-Series - Manual (Page 23)

Page 23
3.5 Extender Beam
Rigging
S-Series | Rigging
PINCH POINT
CAN CAUSE SEVERE
PERSONAL INJURY
WARNING
SAFETY RISK
PAY SPECIAL ATTENTION
When using a highly curved or steeply tilted array, using the S-Series Extender Beam is necessary. Below are the
steps needed to attach the Beam to the S-Series Support Frame.
Fig. 1
Fig. 2
2. Lower the Extender Beam onto the Extender Beam Plates. (Fig. 2)
3. Pin the Extender Beam to the Extender Beam Plates in the
corresponding hole configuration as described in Blueprint AV™ (Fig. 3)
Fig. 3
4. A properly affixed Extender Beam. (Fig. 4)
Fig. 4
1. Remove the Lifting Plates from the S-Series Support Frame and
pin in place the Extender Beam Plates at either end of the support
frame.(Fig. 1)