Adamson S-Series - Manual (Page 24)

Page 24
3.6 Single Point Rigging
Rigging
S-Series | Rigging
WARNING
SAFETY RISK
PAY SPECIAL ATTENTION
PINCH POINT
CAN CAUSE SEVERE
PERSONAL INJURY
Fig. 1
Fig. 2
1. Secure the Lifting Plate to the S-Series Support Frame as described
in the mechanical tab of Blueprint AV™. (Fig. 1)
2. Attach a 5/8” rigging shackle to the top hole of the Lifting Plate. (Fig.
2)
3. Attach motor clasp to the rigging shackle. (Fig. 3) If needed, use an
extra piece of rigging steel to increase distance from the motor to the
frame in order to allow room for a chain bag.
Fig. 3
4. Remove the lifting pin keeping the 4-stack in place on the dolly.
(Fig. 4)
Fig. 4
If only one motor is available, moderately curved and tilted arrays can be lifted using only the S-Series Support
frame. The same procedure can be implemented using the Extender Beam for arrays with a greater angular and tilt
characteristics.