Adamson SpekTrix - Manual (Page 14)

SpekTrix Series User Manual 14 of 72
Adamson Inclinometer Set
#940001
The measuring kit includes a digital inclinometer set and a tape measure
safely secured in a die-cut foam/durable plastic casing. The sensor is fitted
to the rigging frame or placed onto a cabinet which allows the measuring
of the aiming angle.
The sensor is connected to the display with a standard XLR cable
(picture 4) for remote access. When switching the inclinometer on, the laser
beam is automatically activated, facilitating not only the visual control of
the array’s vertical aim but the horizontal positioning as well.
The tape measure included in the kit is used to measure the trim height of
the array, in order to
match it with your Shooter® simulation.
Two separate batteries enable the use of the inclinometer, even if the laser
battery is low.
The sensor is fastened to the rigging frame with a steel safety rope.
Cabling PART #’s
NL8-’ #940054
male-male (picture 2)
NL8-10’ #940055
male-male
NL8-25’ #940056
male-male
NL8-50’ #940057
male-male
NL8-100’ #940058
male-male
1.5 Accesories
Soca 50’ #90051
19 pin 12 AWG
Soca 100’ #90050
19 pin 1 AWG
Soca150’ #900529
19 pin 1 AWG
Soca Splay #90052
19 pin soca to 2 x NL8 (picture 1 & )
Soca Splay Sub #9005
19 pin soca to 4 x NL8 (picture 1)
1.
2.
.
4.