Adamson SpekTrix - Manual (Page 41)

SpekTrix Series User Manual 41 of 72
When arraying with someone else, or without having had prep time between events and a venue requires a new
design, It might be faster to configure the array box by box. This method requires a minimum of 2 persons.
1. Place a person on both sides of the array with a possible third person operating the motor.
2. Follow the steps to hang the subs onto the frame. p. 40
. Cabinet 1: Unhook the bottom push pin to release the enclosure from the stack, pull the rigging wheel’s safety
pin outward. Change the wheel position into the desired position (first enclosure should be set to 4 to attain a
gapless array) Push pin back into place.
4. Lift the enclosure, and place the push pin into place (on the previous cabinet, the rigging frame or in the
cabinet above) to hold the boxes together.
5. Release the following enclosure’s pins, turn the wheel to desired position push the pin back in.
6. Lift and pin to the previous enclosure.
7. Continue this method until all
boxes are pinned together. If
needing more room to work, bring
the motor up to a desired level
every few enclosures.
8. When working on a longer array, one might want to attach
cabling every 4 boxes, in order to reach the top enclosures.
9. Wheel the next stack under the array and follow the previous
instructions.
FOR CABLING INSTRUCTIONS SEE NEXT PAGE
4.2 Flying the Array
6. 5. 4.
9. 8.
7.