Apantac TAHOMA Platform - Manual (Page 49)

APANTAC LLC ● 7556 SW BRIDGEPORT ROAD ● PORTLAND, OR 97224, USA
PHONE +1 503 616 3711 ● FAX +1 503 389 7921 ● [email protected] ● WWW.APANTAC.COM
Page 49 of 67
12B
OPERATION
U
Powering Up
There is no power switch on the Tahoma Multiviewers. Plugging in the power cord will turn on
the Multiviewer. Unplugging the power cord will turn off the Multiviewer.
U
Connection / Indicator / Button Descriptions
• BNC connectors for auto-detect video inputs
• DVI-I connectors for auto-detect high resolution inputs
• 16 embedded audio meters per SDI inputs
• 8 GPI/O on the control board for alarms and recalling presets
• 8 GPI/O on the video processing board for tally, alarm and recalling presets
• 1 Ethernet connection for control and configuration
• 1 RJ45 input for serial connection
• 1 BNC for AES audio output for monitoring
• 1 phone jack on the rear panel for line Level analog audio monitoring
• 1 phone jack on the front panel with volume control for audio monitoring
• 1 BNC for LTC input
• 1 RJ45 for DVI/HDMI(1.2/1.3)/VGA outputs with built in extenders to reach 35 meters (115
feet)
• Rotary switch: Reserved for future use
• Temperature sensor to control fan speed
• LED for input status (present/absent). One LED per input
• 5 buttons on the front panel to recall presets
13B
Optional Hardware
• Unbalanced Analog audio inputs (16 inputs per video processing card)
• Unbalanced AES audio inputs(8 inputs per video processing card)
• Balanced Analog audio inputs (16 inputs per video processing card)
• Balanced AES audio inputs(8 inputs per video processing card)
• Redundant Power Supply
• RJ45 to VGA Receiver