API Audio Rack Ears for the lunchbox - Manual (Page 4)

lunchbox® Rack Mount Conversion Manual 910-0859 REV. A - Page 4
8. Install the final rack ear support
bracket. Use the mounting location
of the handle removed in the
previous step. Be sure to use the
correct set of holes on the rack ear
support bracket. For mounting
locations, refer to the diagram in
step 6. Secure the bracket using two
001-0013 screws and two 002-0003
nuts. Install using a #2 Phillips head
screwdriver and a 5/16” wrench. The
screws go on the inside of the lunchbox chassis.
9. Remove the remaining four bottom feet using a
#1 Phillips head screwdriver.
10. Reinstall the rear panel using the ten screws removed earlier. Remember
to reinstall the lock washer on each screw before installation. Use a #1
Phillips head screwdriver to tighten the screws.
11. Mount both rack ear faceplates using six 001-3002
screws and the remaining six 002-0003 nuts. Use a #2
Phillips head screwdriver and a 5/16” wrench.
12. On the 500-6B, reinstall the blue lunchbox faceplate by reinserting
the mounting screws. Be careful not to damage the LED indicators
when placing them through the panel. On the 8 Slot lunchbox, be
sure to reconnect the front panel LED power indicators to the
motherboard. To avoid damaging the lunchbox, be sure that the
connector is oriented properly before connecting. This completes
the rack ear installation process.