Connecting your set-top to an external esata dvr – ARRIS DCX3510M User Guide User Manual
Page 30
Connecting Your DCX Set-top
B
DCX with OCAP Software DCX3510-M • User Guide
21
365-095-17068-x.1
Connecting Your Set-top to an External eSATA DVR
1. Contact your cable service provider to verify the set-top software necessary to
support External DVR Storage is available in your area.
2. Connect the AC power cord to the external drive and plug the external drive’s AC
power adapter into an electrical outlet.
3. Allow approximately 15 to 30 seconds for the external drive to reach operating
speed.
4. Connect one end of the eSATA cable to the set-top.
5. Connect the other end of the eSATA cable to the external drive.
6. Follow the on-screen instructions.
Note: Only connect external hard drives that have been approved by Motorola for
external DVR service. Connecting an external drive that has not been approved could
result in poor DVR performance.
Figure 9: Connecting Your Set-top to an External eSATA DVR