Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (January 2015) - Manual (Page 204)

Supported IPMI Commands
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54H) 204
The following table lists the request and response data applicable to the Get Serial Output
command.
8.3.3 OEM Set/Get ACPI Power Commands
This command can be used to change payload’s power state.
Table 8-26 Get Serial Output Command
Byte Data Field
Request Data 1:3 Artesyn IANA Number (0065CDh). LSB first.
4 Serial connector type:
0 = Front panel connector
1 = Backplane connector
All other values are reserved.
5 Serial connector instance number. A value of 00h shall be used all other
values are reserved
Response Data 1 Completion code.
2:4 Artesyn IANA Number (0065CDh). LSB first.
5 Serial output selector.
0 = payload interface
All other values are reserved
Table 8-27 OME Set/Get ACPI Power Commands
Command name
NetFn
(Request/Response)
CMD
OEM Set ACPI Power State 0x2E/0x2F 0x17
OEM Get ACPI Power State 0x2E/0x2F 0x18