Artesyn ATCA-7365 Installation and Use (May 2014) - Manual (Page 227)

Serial Over LAN
ATCA-7365 Installation and Use (6806800K65M) 227
Default Gateway MAC : 00:00:00:00:00:00
RMCP+ Cipher Suites : 1,2,3,3
Cipher Suite Priv Max : Not Available
root@localhost:~#
7.4 Establishing a SOL Session
To start a SOL session, the following requirements must be fulfilled:
 An Ethernet LAN connection to the 82576 controller of the ATCA-7365 must exist.
 ATCA-7365 IPMC FW must correspond to version 2.00.7 and above.
Procedure
To establish a SOL session, proceed as follows:
1. Make sure that the requirements detailed above are fulfilled.
2. Compile and install the ipmitool on your target which is destined for opening the
SOL session on the ATCA-7365. For details refer to Installing the ipmitool on page
223 .
3. Apply an IP address to the ATCA-7365 SOL interface - for details refer to Configuring
SOL Parameters on page 224 .
4. If necessary change user and password.
Default user is "soluser" and password is "solpasswd".
5. Configure the network between the ATCA-7365 and your target, which is destined
for opening the SOL session, so that the SOL IP address is accessible.
MAC Address 00:00:00:00:00:00 means the address is shared between base and SOL
interface. The address can be found out in the MAC address record of the FRU.