Artesyn ATCA-7365 Installation and Use (May 2014) - Manual (Page 246)

Supported IPMI Commands
ATCA-7365 Installation and Use (6806800K65M) 246
8.3.1 Serial Output Commands
8.3.1.1 Set Serial Output Command
The Set Serial Output command selects the serial port output source for a serial port
connector.
8.3.1.1.1 Request Data
The following table lists the request data applicable to the Set Serial Output command.
Table 8-19 Serial Output Commands
Command Name NetFn (Request/Response) CMD Description
Set Serial Output 0x2E/0x2F 0x15 See Set Serial Output Command on
page 246
Get Serial Output 0x2E/0x2F 0x16 See Get Serial Output Command on
page 247
Table 8-20 Request Data of Set Serial Output Command
Byte Data Field
1 LSB of Artesyn Embedded Technologies IANA Enterprise number. A value of 0xCD has
to be used.
2 Second byte of Artesyn Embedded Technologies IANA Enterprise number. A value of
0x65 has to be used.
3 MSB of Artesyn Embedded Technologies IANA Enterprise number. A value of 0x00 has
to be used.
4 Serial connector type
0: Face plate connector
1: Backplane connector
All other values are reserved.
Note: Only the faceplate connector is supported. No connector on the RTM available.
5 Serial connector instance number. A sequential number that starts from "0".