Avery Dennison Monarch 9864 Error Messages - Manual (Page 38)

05/08 Rev. AB USER MANUAL Error Messages
9844 – 9854 – 9864
38
5012 Delete H8 loader
Status Error while loading the H8 firmware: the old firmware on the machine could
not be deleted.
Action Press Online to acknowledge.
Reload the firmware.
If the error occurs repeatedly, the bootloader must be reloaded.
5013 Prog H8 loader
Status Error while loading the H8 firmware: the new firmware could not be written.
Action Press Online to acknowledge.
Reload the firmware.
If the error occurs repeatedly, the bootloader must be reloaded.
5014 Power
Action Press Online to acknowledge.
5015 Scanner
Status Error at the scanner.
The scanner is tested during printer initialization by turning it on for a
moment. A properly working scanner sends a reply signal to the printer. No
signal sends a message.
Action Press Online to acknowledge.
Is the red scanner LED light on? If not, there is no power. Check if the
scanner connection cable is plugged in correctly and if the connection cable
is damaged.
Is the yellow scanner LED light on shortly after turning on the printer? If not,
the scanner test was faulty.
5016 ALX Rewinder
Status The output stage board belonging to the rewinder motor is not connected or
damaged.
Action Check if the board is connected properly.
Exchange the board to verify if it is damaged.
5017 Power Supply
Status Communication fault of the power supply while performing the "Head dot
test".
The power supply did not switch to the dot check mode. Also, the power
supply may have caused disturbances on the processor line. Even if the
switchover is defective (the message is continuously displayed), the printer
can be used in normal operation mode.
Action Press Online to acknowledge.