Avery Dennison Monarch 9864 Error Messages - Manual (Page 52)

05/08 Rev. AB USER MANUAL Error Messages
9844 – 9854 – 9864
52
6004 Load H8 program
Status Appears, when
a) no valid H8 firmware is loaded
b) after a boot loader restart
Action Case a)
1. Press Online to confirm.
2. Load H8 firmware.
Call Service for information about loading firmware.
Case b)
Press Online to confirm.
Call Service for information about loading firmware.
6005 Fixfont data
Status Defective fixfonts.
Action Load the new firmware.
Call Service for information about loading firmware.
6006 Speedofont data
Status Defective speedo fonts.
Action Load the new firmware.
Call Service for information about loading firmware.
6010 Printengine soft
Status General software error.
Action Turn off the printer, wait 30 seconds, then turn it back on.
See notes in “General software errors” section.
6012 Start next job
Status The message appears at the end of a printjob if the single job mode
(
SYSTEM PARAMETERS > Single job mode
) is activated. It indicates that the next
printjob should be started.
Action Press Online to acknowledge. Start next printjob.
6030 Param. checksum
Status Wrong parameter checksum.
Action None.