Avery Dennison 676 - Manual (Page 14)

14 • •• • Printer Unpacking / Installation
AC Power Line
AVERY DENNISON requires that the electric service be 10 Amps @ 115VAC or 10
Amps @ 230VAC. This will allow the computer and any additional support or
service equipment to be plugged into the same service.
Any electrical service that is supplying a AVERY DENNISON printer or peripheral
equipment connected to a AVERY DENNISON printer should follow standard
electrical code practices including proper grounding and neutral requirements.
The AVERY DENNISON printer was designed to operate in an industrial setting for
extended periods of time; however, the printer is controlled by a microprocessor that
is very sensitive to brownouts or power spikes. For this reason as well as the
minimum recommended current supply, AVERY DENNISON recommends that a
separate “clean” service be installed or reserved for the exclusive use of the AVERY
DENNISON printer and it’s peripherals.
Printer Unpacking / Installation
Unpacking
The AVERY DENNISON printer is shipped in a large plywood crate that may be
difficult to move by hand.
DO NOT REMOVE THE PRINTER FROM THE CRATE OR UNPACK IN
THE SHIPPING / RECEIVING DEPARTMENT.
NOTE: Unpacking in the shipping/receiving department is not recommended for the
following reasons. First: The plywood crate in which your AVERY DENNISON
printer was shipped allows the printer to be moved with a forklift, forkcart or hand
cart. Because of the weight of the printer, it is easier and safer to use one of these
devices to move the printer to its intended installation location. Second: Leaving the
printer in the crate while it is being moved within your facility will help to protect the
printer during the movements to this new location. Once the printer has reached its
intended location you should begin the unpacking process.
Open the crate from the bottom by removing the six screws along the bottom of the
cover near the floor (See Figure 3).
Remove the plastic over the printer.
Remove all the smaller loss items from in and around the printer.
Unbolt the shipping bracket from the crate bottom.
Lift the printer onto the table.
Remove the shipping brackets from the machine.