Avionics Innovations DMP-100 (MP3 Player) Installation Manual - Manual (Page 6)

DMP-100 INSTALLATION GUIDE PAGE 6 OF 20
P/N DMP010 V1.7
2.0 Mechanical
2.1 Specifications
The DMP-100 is fully contained within a 2-inch (5cm) high standard DZUS mount
enclosure.
Height: 2.0 in. (5.1 cm)
Width: 5.75 in. (14.6 cm) Front Panel
5.0 in. (12.7 cm) System Enclosure
Depth*: 3.25 in. (8.26 cm)
Weight: 0.75 lb (350 g)
* Connector shell protrudes 0.25” (0.64 cm) beyond system enclosure. Allow
an additional 2.5” (6.35 cm) behind unit for mating connector and wiring.
2.2 Mounting Considerations
The DMP-100 should be installed in a normally heated, pressurized section of the aircraft,
however the unit contains no moving parts and does not require special vibration isolation.
The unit may be mounted in an auxiliary area of the instrument panel, in a pedestal, or
anywhere in the aircraft cabin outside of the cockpit. In a severe vibration environment,
the unit should not be mounted vertically with the front panel facing down, to ensure that
the memory card does not accidentally vibrate loose. Otherwise, the DMP-100 may be
installed in any orientation and at any angle.
3.0 Electrical
3.1 General
The following guidelines should be used when installing the DMP-100:
♦ All wiring to be installed in accordance with FAA AC-4313-1A, Chapter 11, Sect. 2
♦ All non-audio wiring to be MIL-W-22759 unless otherwise specified
♦ All audio wiring to be MIL-C-27500 shielded unless otherwise specified
3.2 Connection to Aircraft Power
The DMP-100 accepts a wide range of input voltage directly, without the need for
converters or configuration changes.
Minimum input: 8.0 VDC (1.0 Amp @ 8.0 VDC)
Maximum input: 35.0 VDC (0.1 Amp @ 35 VDC)
Nominal input: 14 VDC / 0.5 Amp
28 VDC / 0.25 Amp
Aircraft power must be supplied via a 2 Amp resettable circuit breaker.