Aviosys 9255Pro - Manual (Page 22)

- 22-
Ref#92550806002
Ping Type: Ping type sets a condition in the case where either all or 1 of the
conditions are met the action will be activated. For instance, if you set Ping Type
to "ALL", all the Ping IP's must fail for the action to be activated. On the other
hand if you set Ping Type to "OR" as long as one of the Ping IP fails it will cause
the action to be activated.
Ping Time Interval (Seconds): The number of seconds between each ping
Ping Response Time (Milliseconds): The number of milliseconds the device
will wait for a response from the pinged device if no ping is detected within this
time it will be considered a ping failure.
Please view the example below for more details:
In the picture above:
1.) Power 1 Ping function is enabled for two websites
2.) The 9255Pro will ping the web address
www.sample.com &
www.google.com
3.) If there is a response within the Ping Response Time the 9255Pro will
send another ping signal the set Ping Time Interval which is 3 seconds for
this example.
4.) If the 9255Pro does not receive a response from the device it will constitute
a Ping Failure.
5.) After 3 consecutive failure the device will go to the Action Delay section. In
this case the device will delay for 3 seconds.
6.) When action delay has been reached the Action will be set off. Here we
have set the 9255Pro to Reset the device.
7.) Once the device has been reset the 9255Pro will go into Startup Delay
mode. In this case it is 3 seconds.
8.) After the startup delay mode has been reached the 9255Pro will check the
Startup Action whether to continue or stop pinging the device. Here we
have it set to Continue.