Baby Lock Crown Jewel II (BLCJ18-2) Manual - Manual (Page 37)

30
System Information
The serial number of the machine is displayed at the
top of the System Information screen. This number
matches the one found on the label at the back of the
machine under the rear handlebar.
Information contained in the white boxes below the
serial number identifies the electronics board version
numbers as well as the version numbers of the Baby
Lock Crown Jewel II and its handlebars. The Lifetime
and Trip (or project) stitch counters count the number
of stitches the machine has performed. The Lifetime
count is the total number of stitches made since the
machine was built. The Trip Counter can be reset to
keep track of the number of stitches made during a
given project. To reset this counter, press the blue “Re-
set” button just to the left of the white “Trip” box. The
Lifetime counter cannot be reset and should be used
as an indicator to determine when general machine
maintenance should be performed by an authorized
Baby Lock Retailer. (Figure 43)
Press the “Main” button to return to the “Regulated” or
“Manual” menu screen or the “Back” button to return
to the “More” menu screen.
Calculator
A basic calculator is provided. (Figure 44)
Press the “Main” button to return to the “Regulated” or
“Manual” menu screen or the “Back” button to return
to the “More” menu screen.
Figure 43
Figure 44
Solid beep for 1/3 of a stitch cycle,
no beep for the rest of the cycle.
Main
System Information
Back
Serial Number
Stitch Counters
Type
HD108151976
Board Version
C-Pod
Handles
2.02
1.00
3.04
2.00
Reset
Lifetime
Trip 000004361
000004361
Main Back
7 8 9
4 5 6
1 2 3
+/- 0 . =
%
CE
C MR
M+
MC
+
X