Baby Lock Eclipse DX (BLE1DX-2) Instruction and Reference Guide User Manual
Page 12
0
Locked Position for Threading
Lower Looper
Threading Your Eclipse
S
E
R
G
E
R
S
E
T
U
P
(fig.A)
1. With the presser foot up and machine lock button in the locked position (fig.A), set the looper
threader selector lever to "L" for lower looper threading (fig.B).
2. Place the thread cone or spool on the far right front spool pin. Slip the thread into the
telescopic antenna thread guide "1" directly above the spool, snap into the thread guide "2"
at the top of the machine, through the slot on the front of the machine. (fig.C, page 11)
3. Pull 18 inches (45cm) of thread through guide "3". Insert the end of the thread into the
threading port "L" about 1 inch (2.5cm). Use tweezers if necessary, to insert the thread end
more easily.
4. Depress the looper threading lever (fig.D, page 11). If the thread does not go through the
lower looper eye with one push, depress the threading lever again until it does.
5. Clip the thread 4 inches (10cm) from the lower looper eye and leave it hanging loose.
6. Move the lock button release lever to the right.