Baby Lock Eclipse DX (BLE1DX-2) Instruction and Reference Guide User Manual
Page 17
S
E
R
G
I
N
G
W
I
T
H
F
A
B
R
I
C
Tension Adjustment
Rethreading Loopers
Rethreading Needles
port, leaving an 18 inch thread tail. Thread the looper as usual. Close the front cover and run
a test sample.
Note:When rethreading your Baby Lock Eclipse using the "Jet-Air Threading" feature,
make certain that the previous thread that was in the tubes is completely removed
from the tip of looper. This will eliminate any chance of the previous thread
obstructing the flow of the air when rethreading the machine.
rethreading the machine.
the machine.
If a needle thread breaks, raise the presser foot and needles to the highest position. Remove
the broken thread and rethread the needle thread guides. Select the "R" or "L" for the needle
being rethreaded. Use the needle threader for exact easier threading. Refer to (pages 12/13)
for further information.