Babycare TENS Elle TENS - Manual (Page 2)

Elle TENS Quick Reference Guide
If you are in labour, please use the quick
reference guide set out below. It is
however recommended that you read the
section entitled “Setting Up Your Elle
TENS” found on page 5 to obtain the best
performance from your unit.
Before using the Elle TENS, please
read the contraindications and
warnings on page 2.
1. Insert 2 x AA batteries in the
compartment at the back of the unit (see
figs 1 and 2, page 6).
2. Insert the leadwire plugs into the top of
the unit (see fig 3, page 6).
3. Insert the pins at the other end of the
leadwires into the sockets attached to the
electrode pads. Do not remove the
electrodes from their backing at this stage
(see fig 4, page 6)
4. Position the electrode pads on the
body as indicated on page 7. A pair of
electrodes must be connected to each
lead wire in order for you to feel any
sensation. The electrode pads must be
peeled away from their backing and
placed directly on your body for you to feel
any sensation.
5. Make sure that the ‘boost’ button at
the side of the unit is NOT pressed in. This
ensures that the unit will start in the
BURST 1 mode (see page 3).
6. Press the (on/off ) to turn the unit
on.
7. Now push the (CH1 +) key until you
feel a pulsating sensation.
8. Repeat the same with the (CH2+)
key.
9. At the onset of a contraction press the
‘boost’ button for the additional surge of
power needed to combat the pain.
10.Release the ‘boost’ button once the
contraction has passed and continue in
the BURST 1 mode as before.