Baumatic BCS450SS - Manual (Page 28)

INSTALLATION
The installation must be carried out by a suitably
qualified person, in accordance with the current version
of the following.
o
UK Regulations and Safety Standards or their European
Norm Replacements.
o
Building Regulations (issued by the Department of the
Environment).
o
Building Standards (issued by the Scottish Development
Department).
o
IEE Wiring Regulations.
o
Electricity At Work Regulations.
Before connecting the appliance, make sure that the supply voltage
marked on the Rating Plate corresponds with your mains supply voltage.
WARNING: THIS APPLIANCE MUST BE EARTHED.
o
This appliance should be wired into a 13A double pole switched
fused spur outlet, having 3 mm contact separation and placed in an
easily accessible position adjacent to the appliance. The spur outlet
must still be accessible even when your oven is located in its
housing.
rovided and then immediately close the terminal block cover
again.
onductor must always be 10 mm longer than the
line conductors.
the temperature of the mains
supply cable does not exceed 50°C.
which can be obtained from the
Baumatic Spares Department.
o
To connect the oven power cord, loosen and remove the cover on
the terminal block, in order to gain access to the contacts inside.
Make the connection, securing the cord in place with the cable
clamp p
o
If you have to change the oven power cord, the earthing
(yellow/green) c
o
Care must be taken to ensure that
o
If the mains supply cable is damaged, then it must be replaced by
an appropriate replacement
28