Baumatic BMC253SS - Manual (Page 30)

o
WARNING: THIS APPLIANCE MUST BE EARTHED.
o
This appliance is supplied with a moulded plug, which must be
connected to an earthed socket.
o
If in future you need to change the fuse in this plug, then a 13
amp ASTA approved (BS 1362) fuse must be used.
o
If the earthed socket is not accessible after the appliance is
installed. Then the microwave must be wired into a 13 A double
pole switched fused spur outlet, having 3 mm contact separation
and placed in an easily accessible position adjacent to the
appliance. The spur outlet must still be accessible even when
your microwave is located in its housing.
o
The wiring in the mains lead is coloured as follows:
Brown
Live
Blue Neutral
Green and yellow Earth
o
As the colours of the wires in the appliance’s mains lead may not
correspond with the coloured markings identifying the terminals
in your spur box, please proceed as follows:
The brown wire must be connected to the terminal marked “L”
(live), or coloured red.
The blue wire must be connected to the terminal marked “N”
(neutral), or coloured black.
The green and yellow wire must be connected to the terminal
marked “E” (earth), or by the earth symbol, or coloured green
and yellow.
o
When the connection is completed, no stray strands or cut wire
should be present. The cord clamp must be secured over the
outer sheath.
o
Broken or damaged power leads must only be replaced by a
suitably qualified person. A power lead of a similar type must be
used in replacement.
Before beginning to install your appliance, check that
there is no sign of damage (on the inside or the
outside of the microwave), and that there are no
packing materials or accessories inside the cavity.
Remove any protective film on the microwave.
30