Digital Media 900TL - Manual (Page 4)

Note:
The rear panel shown here is used only when the MAU
is in a single-slot hub configuration.
1 ) Ring In LED. Lights with a Ring In connection.
2 ) Ring Out LED. Lights with a Ring Out connection.
3) Power Connector. Provides power connection for the
MAU.
4 ) Ring In Connector. Connects Ring In to the Ring
Out connector of a MAU or repeater.
5 ) Ring In Autowrap Switch. Determines whether the
MAU automatically loops back when it detects a
disconnected link on Ring In. If the Ring In port
connects to a device with Digital’s Autowrap, set the
switch to 1 to enable Autowrap. If the Ring In port
connects to a device without Digital’s Autowrap, set
the switch to 0 to disable Autowrap.
6 ) Ring Out Connector. Connects Ring Out to the Ring
In connector of a MAU or repeater.
7 ) Ring Out Autowrap Switch. Determines whether the
MAU automatically loops back when it detects a
disconnected link on Ring Out. If the Ring Out port
connects to a device with Digital’s Autowrap, set the
switch to 1 to enable Autowrap. If the Ring Out port
connects to a device without Digital’s Autowrap, set
the switch to 0 to disable Autowrap.
8 ) Not used. Reserved for out-of-band network
management.
Rear Panel of DEChub ONE MAU 900TL
4 DECmau 900TL
LKG-8146-93I
2
1
3
4
5
6
7
8