Besafe iZi Comfort X3 ISOfix User Manual

Page 2

Advertising
background image

2

3

!

!

Thank you for choosing BeSafe iZi Comfort ISOfix.

Contents

Vital information

BeSafe has developed this seat with much care, to protect your

child during the next phase of her or his life.

Vital information

Preparing to install

Forward-facing ISOfix installation

Removing the seat

Forward-facing belt installation

Removing the seat

Positioning of the child

Sleeping position

Removing and refitting the cover

Cleaning instructions

Warning: potential misuse

Important advice

Guarantee

Point of sale information

• It is NOT ALLOWED to mount the seat in a front

passenger seat WITH AN ACTIVATED AIRBAG.

• iZi Comfort ISOfix can be installed forward-facing

with the ISOfix anchorage in a car equipped with

ISOfix anchorage points.

• iZi Comfort ISOfix can be installed forward-facing with a 3-point

car belt, approved to UN/ECE Regulation No. 16 or other

equivalent standards.

• iZi Comfort ISOfix is approved in group 1, forward-facing from

9-18 kg.

• Read the car list to find out whether your car model is

approved to use the seat.

• The harness straps must always be locked when the child is in

the seat.

• The harness straps must be tightened without slack and

not twisted.

• The seat cover contains magnets in the areas with the orange

indications. Magnets can influence electronic equipment

like pacemakers.

• The floor support must always be used. Make sure that the

floor support is fully pushed down.

• When installed with ISOfix: Make sure the indicators are green

before you drive.

• When the child weighs over 18 kg or the shoulder height grows

above the highest position of the shoulder straps, the child

must change to a group 2/3 seat.

• After an accident, the seat must be replaced. Although it may

look undamaged, if you were to have another accident, the

seat may not be able to protect your child as well as it should.

• Prevent the seat from becoming trapped or weighed down by

luggage, seats and/or slamming doors.

• Before every use, make sure the harness is not damaged

or twisted.

• Make sure you can fit no more than one finger between the

harness and your baby (1cm).

• If in doubt, consult either the child restraint manufacturer or

the retailer.

It is important that you read this user manual BEFORE installing

your seat. Incorrect installation could endanger your child.

3

3

4

5

7

8

10

11

12

13

15

15

17

18

19

Advertising
This manual is related to the following products: