Besafe iZi Comfort X3 ISOfix - Manual (Page 8)

14 15
wash with similar colours
• It is NOT ALLOWED to mount the seat in a front
passenger seat WITH AN ACTIVATED AIRBAG.
• Install only with 3-point car belts, approved
to UN/ECE Regulation No. 16 or other
equivalent standards (28).
!
Warning: potential misuse
OK
NO
shoulder
belt
hip belt
(28)
Cleaning instructions
• The cover of the seat must be washed according to the
instructions on the inside of the cover (27).
• DO NOT use any aggressive cleaning products; these may
harm the construction material of the seat.
(27)
• Make sure that the harness straps are fixed in the right way,
after fitting the cover.
!
Removing the cover: alternative 2
Pay attention when you
remove the cover, as fitting
the cover is done in the
opposite way.
The cover of the head rest can be taken off
separately by disconnecting the hooks at the
backside and pulling off the fabric to the front.
1-
2-
3-
(26)
Refit the cover
Pull the harness straps through the opening of the seat cover
and lock the harness buckle. Pull the crotch strap through the
opening of the seat part.
Pull the loops of the harness straps from the bottom of the
seat part through the openings to the hooks in the bottom
of the seat. Hook both harness straps on the metal belt
hooks and pull the straps firmly to ensure that they are
correctly installed.
Pull the head rest in the highest position. Mount the head rest
cover and connect the hooks at the back side. Pull the harness
straps through the holes. Connect the loose bottom part of the
head rest fabric with the plastic part under the head rest.
2-
3-
1-
To remove the seat cover,
the harness straps must be
released at both sides. See
red circle. Start to take off the
lower seat part and unhook
both harness straps from the
metal belt hooks (26).