Besafe iZi Comfort X3 ISOfix - Manual (Page 7)

12 13
Position the shoulder straps
over the orange marking at
sides of the seat to keep the
harness open while you position
the child (19).
When the child is positioned,
place the shoulder straps over
the child’s shoulders and close
the buckle: CLICK! (20).
Pull the harness strap through
the central adjuster in the
direction of the green arrow
straight up-/forwards. Continue
pulling until the harness is a
comfortable but firm fit (21).
Sleeping position
• The seat has 4 reclining positions.
• By turning the reclining
knob, the seat can be put in
another position (22).
! Make sure that the harness straps are always locked and
tightened when the child is in the seat.
5-
6-
7-
(19)
(20)
(21)
(22)
Removing the cover: alternative 1
Pay attention when you remove
the cover, as fitting the cover is
done in the opposite way.
The cover of the head rest
can be taken off separately by
disconnecting the hooks at the
backside and pulling off the
fabric to the front.
Start to take off the
lower seat part (25).
1-
3-
2-
Removing and refitting the cover
• There are 2 versions of the
fabric cover. If there are
velcro squares (see green
arrow (23/24)), follow the
steps of alternative 1. If
there are no velcro squares
go to alternative 2.
Refit the cover
Mount the top part and then the shoulder parts. Mount the
seat part and bring the seat cover under the rear parts of
the sidewalls.
Pull the head rest in the highest position. Mount the head rest
cover and connect the hooks at the back side. Pull the harness
straps through the holes. Connect the loose bottom part of the
head rest fabric with the plastic part under the head rest.
Pull the harness straps through the opening of the seat cover
and lock the harness buckle. Pull the crotch strap through the
opening of the seat part.
3-
1-
2-
(23)
(24)
(25)