Beurer HTE 50 - Manual (Page 23)

23
Using the crimping iron
• Attach the straightening/crimping
attachment [12] to the multi-function styler.
• Slide the selector switch [11] into the
"Crimp" position [c]. Now the crimping iron
[F] can be used.
• Divide your hair into individual strands. Hold
the strands taut and place them between
the crimping iron [F] at the roots.
• Close the crimping iron [F] for about 10
seconds. This way you will obtain the best
results without overstraining or damaging
your hair.
• Open the crimping iron [F] again and take
the hair strands out.
• Repeat the process until you have reached
the hair ends.
After use
• Switch off the unit by moving the slide
switch [5] into position 0.
• Place the multi-function styler with the stand
down onto a stable, horizontal and
non-combustible surface or hold the
multi-function styler in your hand to let it cool.
• Remove the plug from the socket after each
use.
• Do not wind the mains cable [9] around the
unit!
• Store the unit in a dry place that is out of
reach of children.
• The unit can be hung on a hook by the
hanging eyelet [8].
7 Cleaning and care of the unit
Notes
• Your unit is maintenance-free.
• Protect the unit from dust, dirt and moisture.
Cleaning
Important
• Always remove the plug from the socket
before cleaning.
• Ensure that no water enters the inside of
the unit!
• Do not wash the unit in a dishwasher!
• Do not use any strong, sharp, abrasive,
corrosive cleaning agents or hard brushes!
• Do not clean it with any highly flammable
liquids!
• The unit and the attachments can be cleaned
with a soft cloth that has been moistened
with warm water.
• Dry the unit and the attachments carefully
after cleaning them!