Broadata Communications 200E-CC - Manual (Page 6)

BCI 200E-CC/200E-CCP User’s Manual
Universal Fiber Optic Card Cage System
Broadata Technical Support, [email protected] 7
Refer to the individual user manuals to interface each I/O card
in your system for the appropriate signals and terminals. When
interfacing has been completed, and your system is ready to
be powered up, use the power switch(s) under the power cord
connector. If using a redundant system, either power supply is
capable of powering the system, so either one can be enabled
first.
2.3 AC Power Connection Guideline
Congratulations! You are now ready to power up the BCI 200E/
200E-CCP and set up your network connection. In order to
make sure that you have a proper installation, please observe
the following:
1. Your AC jack has power.
2. Your electrical system has proper grounding (this ensures
that your power supply does not suffer from voltage
variations).
3. Power Surge Protection. This is optional, but highly
recommended. A UPS system provides voltage regularity
as well as prevents spikes from occurring, thus protecting
your 200E/200E-CCP from sensitive voltage conditions.
The 200E/200E-CCP derives power from an internal power
supply. This power supply is a 90-240 VAC, 50-60 Hz.
To provide power to the 200E/200E-CCP, simply connect the
200E/200E-CCP power cord, already provided with the units,
and connect it to the wall jack. (You will find one power cord
per unit). Once the power cord has been connected to the wall
jack, connect the other end, turn the switch on and the unit
should power up immediately.