BSS Audio FDS-334T Owner's Manual - Manual (Page 20)

2 0
Programs
Program Storing
A Program can be stored in any one of the 60 available memory locations. Pressing STORE/
ENTER displays the Store screen with the last used Program on the screen. Pressing either up/
down or turning the rotary encoder enables the selection of the required memory for storing
your new Program. Pressing any of the Input, Output, RECALL or UTILS buttons at any time will
leave the Store screen.
Program Naming
The Program can be given a name using alphanumeric characters up to 8 digits in length. To
input a new name, press the > to move the cursor into the name area of the screen. The screen
will display the current name of the Program that is being edited (after a short period of time),
and the cursor will locate under the first character to be modified. Characters can be changed
using either the up/down keys or the rotary encoder and the next character along can be se-
lected using the > key. Use the < key to go back to change or correct previously set characters.
Pressing STORE/ENTER a second time will perform the store if the Program location is not
locked.
Program Lock
User Programs can be locked to prevent overwriting of memories too easily. A store will fail if
the lock key character is displayed when STORE/ENTER is pressed. The ‘PROGRAM LOCKED!’
message will stay on the screen for a few seconds. After this message has disappeared the lock
can be turned off with either the down key or by turning the rotary encoder anticlockwise. The
Store will now be successful.
Store has failed because the Program is locked.
After the store operation the Minidrive asks whether the Program should be stored ‘Locked’ or
‘Unlocked’. Turning the rotary encoder will select between ‘Locked’ and ‘Unlocked’, select
your preference and press STORE/ENTER a third time to complete the operation.
Screen Explanations
This section covers the various screens that are displayed when in particular modes of operation
on the Minidrive. These include Utilities, Input and Output modes.