Datamax DGL - Manual (Page 42)

42
Chapter 3
The Media Handling menu setting can be set up through the Software Switch
Setting command <STX>V. Enabling the Cutter bit selects ‘Cut’ Media
Handling, and the Present bit selects ‘Tear-Off’. Disabling cutter or present bit
selects media handling setting ‘Continuous’.
The <STX>V command can be ignored by setting the DGL Advanced-User
menu ‘Soft. Switch (V)’ to Ignore.
Emulations
Datamax allows emulation of legacy and other resolution printers through
menu settings (Plus, Allegro, Column and SOP emulations).
None of these
emulations are supported on DGL.
Printer Configuration
All DPL commands affecting the printer configuration will be ignored.
DGL has its own configuration management to save / load configuration
settings that can be used instead. See table below for the affected commands
(all ignored):
Command Reference
The following sections explain why certain commands are partially supported
or ignored.
Ignored Commands
<STX>Kb Backfeed Time Delay
<STX>K- Top-of-Form. Offset Distance
<STX>KF Set Present Distance
<STX>M Set Maximum Label Length (Distance to search for Gap before
error)
<STX>R Ribbon Saver
<STX>b Set Cutter signal time
Cmd Desc
<SOH>U Update System Database with Current Database
<STX>KC Get Configuration
<STX>Kc Set Configuration
<STX>Kd Set File as Factory Defaults
<STX>KF Select Factory Defaults
<STX>Kx Delete
Configuration File
e Recall Printer Configuration