BUG-O Systems MM-1 - Manual (Page 26)

26
PROGRAMMING EXAMPLE
To cut a slot in a pipe like the one shown below:
1. The cut is split into segments of straight lines and circular arcs that make up the desired pattern.
2. Next, these segments should be listed in a table (as shown), with the Type, Quadrant, and
required Dimensions (refer to the Programming Segment Chart).
3. To program the shape, press “A” on the pendant keypad, then enter the total segments at the
prompt (6 for this example).
4. Next enter the data for each segment such as Type, Quadrant, and Dimensions, as prompted.
5. Finally enter an End of Segment slowdown value, and the display will read “Ready”.
6. IN THE SHAPE PROGRAM, FOR THE FIRST CUT OF A GIVEN DIAMETER, THE PIPE
DIAMETER MUST BE ENTERED. Press “E” on the pendant keypad, the display will prompt for
the pipe diameter, and then the Slowdown value.
The first Segment is a clockwise 90 degree arc,
which is Type 1, Quadrant 3 and the required
Dimension is the radius, set here as 40 mm.
Segment Type Quadrant Dimension
1 1 3 400
2 3 2 600
3 1 2 400
4 1 1 400
5 3 4 600
6 1 4 400