BUG-O Systems SE-2PTD - Manual (Page 14)

14
PROGRAMMING, CUTTING HOLES / TYPE 5
To program TYPE 5 Holes utilizing the “Pipe Program”. The machine is programmed to cut
holes in pipes for branch joints, either square (t-joints) or angled (laterals). The joint must be on
Centerline.
The Display will ask for:
1. The small diameter, and then the large diameter. Enter the diameter of the branch
pipe for small diameter, as shown in the diagram below, and the diameter of the pipe
being cut for the large diameter.
2. Next the display will ask for the angle. Enter the angle, in degrees X 100 (e.g. for 60
degrees, enter 6000). For square cuts you must enter 9000 (for 90 degrees).
Large Diameter
Angle
Small Diameter