BUG-O Systems SE-2PTD - Manual (Page 22)

22
MAKING A CUT
TO MAKE A CUT
1. Set up the machine with pipe in position and power “ON”
2. Program the desired cut. (Refer to the programming sections in this manual).
3. Push the STOP / RESUME button and use the MANUAL JOG to move the torch to
the starting point.
4. Push the RESET button to fix the starting point.
5. For oxy-fuel, turn on and ignite the pre-heat gasses, and wait until it is hot enough to
start the cut. Push the START / RESUME button, and the solenoid for cutting oxygen
or plasma trigger is turned on and the machine starts the cut (after the delay which
has been set for plasma).
NOTE: TYPE 4, MITER
If a cutback dimension has been entered, the machine will make one cut, shut off the gas or arc,
back up for the given distance, and rotate 180 degrees. The machine will pause until the START
/ RESUME button is pressed again, and them repeat the same cut but rotated 180 degrees from
the first cut.
TO MAKE A DRY RUN WITHOUT CUTTING
1. Push the STOP / PAUSE button and hold it down.
2. Push the START / RESUME button and hold it down.
3. Release the STOP / PAUSE button quickly, after step two above.
4. Release the START / RESUME button.
The machine will move along the programmed cut without turning on the contacts for plasma, or
the cutting solenoid.