BUG-O Systems Modular Drive System - Manual (Page 39)

39
MDS-1060-10 10' (3 m) REMOTE CONTROL CABLE
MDS-1060-25 25' (7.6 m) REMOTE CONTROL CABLE
The optional Remote Control Cable allows the operator
to perform work in confined areas where it is difficult to
reach the controls. To use the remote cable, detach the
control module from the master drive. Fasten the Master
Drive Adaptor Plate to the drive unit using the four 8-32 x
3/8 long captive screws provided with the remote cable.
Attach the Control Module Adaptor Plate to the control
module using the control module’s captive screws. The
Master Drive Unit is now ready for remote control.
MOUNTS TO
CONTROL MODULE
MOUNTS TO
MASTER DRIVE
MDS-1060-_ REMOTE CONTROL CABLE
CAS-2050 AUTOMATIC HEIGHT CONTROL / Linear Weaver
The CAS-2050 is an Automatic Height Control ( AHC) for the Linear Weaver (WPD-1100) that controls
the welding tip to work distance and maintains a constant weld current, helping to provide uniform weld
penetration. The CAS-2050 senses the actual weld current, compares this value to the set point, and raises
or lowers the welding gun accordingly.
CAS-2060 AUTOMATIC HEIGHT CONTROL / Pendulum Weaver
The CAS-2060 is an Automatic Height Control ( AHC) for the Pendulum Weaver (WPD-2100) that controls
the welding tip to work distance and maintains a constant weld current, helping to provide uniform weld
penetration. AHC senses the actual weld current, compares this value to the set point, and raises or lowers
the welding gun accordingly. It features a built-in time delay after the arc is struck, and automatically shuts
off when the current drops too low (generally below 60 amps).
CAS-20__ AUTOMATIC HEIGHT CONTROL
CAS-2050
AUTOMATIC HEIGHT CONTROL / Linear Weaver
CAS-2060
AUTOMATIC HEIGHT CONTROL / Pendulum Weaver